may openser fails to start due a configuration error - check the log for
potential errors and hints.
regards,
bogdan
Padmaja RV wrote:
Hi!
Thank you for the mail.
I have already followed all the steps mentioned in the links .
http://openser.org/dokuwiki/doku.php?id=install_and_maintain_openser_from_c…
http://openser.org/dokuwiki/doku.php?id=make_openser.init_script_work
... pls see my previous mail below.... after all these steps when i
actually want to run openser from /etc/init.d/openser start command,
it starts monit daemon and then the command prompt appears back.....
when i go to the directory /var/run/ i cant see the openser.pid file
and also the monit daemon after a while responds that it could nt
start openser. this i can see at
http://localhost:2812 where the web
interface for the monit is running...........
Please let me know the problem free and preferred source of running
openser.... which is the best way to run openser (is it from binary or
cvs)?
Thanks and Regards,
Padmaja
----- Original Message ----- From: "Bogdan-Andrei Iancu"
<bogdan(a)voice-system.ro>
To: "Padmaja RV" <padmaja.rv(a)vodcalabs.com>
Cc: <users(a)openser.org>
Sent: Tuesday, May 30, 2006 1:20 PM
Subject: Re: [Users] how to run openser through monit daemon?
Hi,
See
http://openser.org/dokuwiki/doku.php?id=make_openser.init_script_work
regards,
bogdan
Padmaja RV wrote:
Hi all!
I have installed openser through CVS from the following link
http://openser.org/dokuwiki/doku.php?id=install_and_maintain_openser_from_c…
till the 8 th step in the link everything went well fine. in the 9
th step, there is a link to make oepnser.init script work and i did
all the steps as described. I downloaded and installed the monit
daemon to start openser thru it. however, now if i type
/etc/init.d/openser start, it says command monit to start openser
and then the command prompt appears back. i dont see the tcp and udp
ports (5060 ) and other information etc when the openser is
started.....and i cant figure out if it is running at all.....if i
issue ps command, i dont see any pid for openser.....if i open the
web interface of the monit daemon, i see that it is trying to start
the openser but after some time it shows failed to start......
please let me know what to do asap.....
Thanks