Hi bogdan,
now it works i can see the debug messages and OpenSER correctly swap
From/To for the accounting.
But i didn't change the config, the only thing is that now signalling
message come from another proxy and not directly from UA.
thank you for the support.
On Mon, 2006-07-03 at 09:44 +0200, tele wrote:
Hi Bogdan,
I've updated to last CVS-head version. but in the log i can't see debug
messages.
maybe there is an error in my accounting configuration. pls have a look:
modparam("acc", "log_level", 2)
modparam("acc", "log_fmt", "cdfimorstup")
modparam("acc", "report_ack", 0)
modparam("acc", "detect_direction", 1)
modparam("acc", "radius_flag", 3)
modparam("acc", "radius_missed_flag", 5)
modparam("acc", "radius_config",
"/usr/local/etc/radiusclient-ng/radiusclient_auth.conf")
modparam("acc", "radius_extra",
"h323-setup-time=$avp(setup_time);
h323-connect-time=$avp(connect_time);
h323-disconnect-time=$avp(disconnect_time);
h323-remote-address=$avp(remote_address)")
and before loose_route() i have:
if (is_method("BYE"))
{
setflag(3);
setflag(5);
};
is it correct?
Bogdan-Andrei Iancu wrote:
Hi,
as I saw in the log, the FROM restoring in BYE works properly, so
RR/Route processing is fine. Are you sure you enabled the accounting
for BYE?
just in case, I added some more debug messages about this on cvs -
please update and see the output. You should get:
DBUG:acc:acc_onreq: UPSTREAM req detected -> flaging it
and
DBUG:acc:fmt2strar: UPSTREAM flag set -> swap F/T
_______________________________________________
Users mailing list
Users(a)openser.org
http://openser.org/cgi-bin/mailman/listinfo/users
_______________________________________________
Users mailing list
Users(a)openser.org