1 Feb
2007
1 Feb
'07
10:43 a.m.
you should remove t_relay_to_udp, as well as the break and make sure
that on return to failure_route you don't run more commands.
g-)
Shaun Hofer wrote:
I tried making route just to house the commands, I
call for both:
route[7] {
revert_uri();
rewritehostport("202.168.41.218:5060");
append_branch();
t_relay_to_udp("202.168.41.218", "5060");
break;
}
When I did this I found that it wouldn't work properly. I did play around with
putting something like use_mediaproxy and calling other routes but seemed
like they failed to be called correctly. I'm thinking either I mediaproxy
all traffic before from the start or let rtp travel directly between UA and
Asterisk.
On Wednesday 31 January 2007 18:21, you wrote:
You could create a route and then call the route
from failure_route.
However, I'm not sure if that will work as the INVITE was already sent
to the UA not responding. But try.
g-)
Shaun Hofer wrote:
> Hi,
>
> I wish to forward busy and no answer calls to Asterisk, and have the RTP
> stream go through mediaproxy. At the moment, some calls use mediaproxy and
> some don't. If the call is not using mediaproxy to get it too. I have
>
noticed
> that I can't call use_media_proxy() from
failed route. I don't want to use
> mediaproxy for every call between UA's, if not needed. Any suggestions on
>
how
> I might be able to get calls to use
mediaproxy if forwarded ?
>
> current fail route:
>
> failure_route[1] {
> if (t_check_status("487")) {
> break;
> };
> if (isflagset(26) && t_check_status("486")) {
> avp_delete("s:fwdbusy");
> resetflag(26);
> revert_uri();
> rewritehostport("202.168.41.218:5060");
> append_branch();
> t_relay_to_udp("202.168.41.218", "5060");
> break;
> };
> if (isflagset(27) && t_check_status("408")) {
> avp_delete("s:fwdnoanswer");
> resetflag(27);
> revert_uri();
> rewritehostport("202.168.41.218:5060");
> append_branch();
> t_relay_to_udp("202.168.41.218", "5060");
> break;
> };
> end_media_session();
> }
>
>
> Thanks
>
>