Hello.
I am working with level3 also... They
require inbadn DTMF and you are trying to use rfc2833..
U have to change config of the whatever
SIP UA you use from your side and configure it to use G711/inband DTMF
From:
serusers-bounces@iptel.org [mailto:serusers-bounces@lists.iptel.org] On Behalf Of scm-j@nuntius.com
Sent: Thursday, February 17, 2005
12:33 PM
To: serusers@lists.iptel.org
Subject: [Serusers] Fax problem
with SER/Asterisk
I am facing some problems with sending fax calls. I am using
G.711 codec. However, my service provider (Level-3) does not support T.38 fax
relay.
According to Level-3 they “think” the problem
lies in the “Media Description” field of the SDP message I am
sending them. The problem is related to the “Media Format”
sub-field (value 101) that I am sending, which according to them should
be removed.
The SDP “Media Description” field I am sending,
looks as follows:
“m=audio 20744 RTP/AVP 0 101”
which is decoded by Ethereal as follows:
Media Type: audio
Media Proto: RTP/AVP
Media Format: ITU-T G.711 PCMU
Media Format: 101
My call is initiated by Asterisk which is sent to Level-3
via SER
Asterisk -à SER -à Level-3
The SIP call flow looks fine for the call. The sending fax
sends the page and then gives an error. The receiving side gives me an error
and prints a blank page.
My questions are as follows:
1) Could the
“Media Format” 101 be the problem? If so, how do I remove the 101?
This change is probably in Asterisk, as it initiates the call, and not SER, or
probably both.
2) If not,
should I be looking elsewhere in SER/Asterisk to solve this problem?
regards,
SCM