RE: [Serusers] Newbie help

Hi, I too I'm not sure what the problem is with that but have found if you add "_udp" to the end it works. t_relay_to_udp("192.168.1.11", "5060"); or "_tcp" -----Original Message----- From: serusers-bounces(a)iptel.org [mailto:serusers-bounces@lists.iptel.org]On Behalf Of B. J. Bomar Sent: 12 February 2004 16:24 To: serusers(a)lists.iptel.org Subject: [Serusers] Newbie help Hello all. I am trying to set up ser to act as a simple sip relay. I have found a couple of config files that I have tried, but none seem to load without errors. I narrowed it down to where they call t_relay_to, so I created the following test config. loadmodule "/usr/lib/ser/modules/tm.so" route { t_relay_to("192.168.1.11", "5060"); } It too fails to run, and this is the message I am seeing in syslog. Feb 12 10:22:48 ratbert ser: parse error (3,44-45): unknown command, missing loadmodule? I am totally stumped on this issue. Any help would be greatly appreciated. Thanks, B. J. ------------------------------------------------------------------------------------------------------- This email, and any files transmitted with it, is copyright and may contain confidential information. The contents are intended for the use of the addressee(s) only. Unauthorized use may be unlawful. If you receive this email by mistake, please advise sender immediately. The views of the author may not necessarily constitute the views of Telco Electronics Limited. Nothing in this mail shall bind Telco Electronics Limited in any contract or obligation. Telco Electronics Limited 6-8 Oxford Court Brackley Northants NN13 7XY Tel 07000 701999 Fax 07000 701777