Hi,
the M$ messenger is know to misuse maddr parameter in the uri. You can check your message if it does contain maddr and then try compile ser with HONOR_MADDR option. It should work; if not attach network capture of the sip traffic.
Michal
On Čt, 2007-05-31 at 11:32 +0545, KUMAR wrote:
hi all, I've started using SER 2.0 rc1 and am having a bit of problems with UA behind NAT. I'm using Windows Messenger 5.1 as the UA. Everything works fine when both UAs are not behind NAT. But when I place one of the UAs behind NAT, then, here's what happens, in this order
UA Behind Nat ----------MESSAGE------>UA outside NAT..............ok UA outside NAT-----------MESSAGE------->UA behind NAT.............OK UA behind NAT------------MESSAGE------->UA outside NAT.............message is stored by msilo module and sent after some time.
The log shows: MSILO: the downstream UA doesn't support MESSAGEs
Notice that this only happens once a message from outside of NAT is sent to UA inside NAT. I am using RTP Proxy for NAT solution which is on the same system as SER. Moreover, I also cannot signout using the Windows Messenger.
However, when I tested using XLite, None of the above mentioned problems arose. Can anyone please suggest me as to where the problem might be.
The ser.cfg that I'm using is the one from the iptel site, the one with NAT & RTPproxy. I am also attaching the ser.cfg. Thank you in advance. Kumar _______________________________________________ Serusers mailing list Serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers