8 Jun
2006
8 Jun
'06
2:05 p.m.
Hi,
Check library (.so files) paths in ser.cfg file and if not correct, give the correct path
for each library. Then run ser again, it will definitely work.
Regards,
Benjamin.
-----Original Message-----
From: Alexandr Dubovikov [mailto:shurik@start4.info]
Sent: Thursday, June 08, 2006 5:14 PM
To: Shyamsundar, Purkayastha (Purkayastha)** CTR **
Cc: 'serusers(a)lists.iptel.org'
Subject: Re: [Serusers] novice issue
On Thu, Jun 08, 2006 at 04:48:24PM +0530, Shyamsundar, Purkayastha (Purkayastha)** CTR **
wrote:
Hi all
Just started using ser but i am stuck at the first step itself
i downloaded ser-0.9.6_linux_i386.tar
untared it , set the cfg file and modules in correct path as per cfg file
and ran ./ser from the sbin directory
and it says
ERROR in cfg file ( 24 errors)
at first, check you configuration with "ser -c"
and set the debug level to 4 in your ser.cfg , after it you can see where is a
mistake.
Wbr,
--
Alexandr Dubovikov * baron@iRC RusNet * mailto:shurik@start4.info
AD1-UANIC * ICQ: 122351182 * http://www.start4.info
_______________________________________________
Serusers mailing list
Serusers(a)lists.iptel.org
http://lists.iptel.org/mailman/listinfo/serusers