It is unclear from your messages exactly how much work has been put into the Cisco config at this time. Without knowing anything more about your config I'd suggest you check to see if the sip-ua and the appropriate dial-peer statements are defined. You'll want something similar too...
sip-ua retry invite 3 retry response 3 retry bye 3 retry cancel 3 timers expires 300000 sip-server dns:<your sip proxy srv name or IP address>
dial-peer voice 10 voip description Only peer for inbound to SIP Proxy huntstop preference 2 destination-pattern 78[1-9] progress_ind setup enable 3 session protocol sipv2 session target sip-server dtmf-relay rtp-nte no vad !
dial-peer voice 11 pots description Only peer for outbound 5-digit calls preference 3 destination-pattern 4.... direct-inward-dial port 1/0:23 prefix 23
If all else fails debug ccsip messages will give you some feedback as to what is happening with the call.
good luck - steve
Miquel wrote:
I have a big problem with a gateway (cisco) and ser. Phone to phone with sip it's ok and when i do phone to pstn the packets arrive to gateway but the line is busy and the message (when i made a capture with ethereal ) is -BAD REQUEST Invalid IP.
I don't know what i have to configure. I think the ser.cfg is well because the packets arrive to the gateway a it reposes.
My quenstions:
- I have to register the gateway
- What i have to do
Thanks
Miquel
Serusers mailing list serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers