16 Apr
2008
16 Apr
'08
2:07 p.m.
Sorry for resuming the post..
I can't understand how to handle failure messages after parallel forking. I
need a particular configuration or OpenSER must handle them the same way of
a single message?
I'm using OpenSER 1.2.3-tls and also using debug mode I can't see nothing
special.
Thanks.
Regards,
Antonio.
2008/4/15, Antonio Reale <ant.reale(a)gmail.com>om>:
Hi all,
I have a Linksys SPA2102 with 2 phones configured with the same
account/number. If I call that number both phones ring and all is OK.
The problem is that if I set a call forwarding on one of the two line on
the SPA only one phone rings.
Openser receives the 302 message from the SPA but the failure route that
contains t_check_status("302") is not called.
The forwarding works if only one line is connected.
How can I handle the 302 in this situation?
Thanks in advance.
Regards,
Antonio.