Hello,

I am using kamailio 5.3 + rtpengine module + sipwise rtpengine in a IMS test environment. I have and issue with ims_qos module and Rx AAR command.

PCSCF is configured with
#!define WITH_RX                                                                                                                                                                
##!define WITH_RX_REG
#!define WITH_RX_CALL

I have 2 test phones connected. Both of them use ipv6.
PCSCF has ipv4 and ipv6 address.
All other nodes - SCSCF, ICSCF use ipv4.

Simple scenario UE1 calls UE2. UE2 is replying with 183 session progress and then RX AAR is sent by PCSCF to PCRF/PGW. The problem is that AVPs Media-Sub-Component Flow-Description include ipv4 address of the proxy and ipv6 address of the UE.

Example:
permit out 17 from 192.168.1.1 34998 to fd18::1:2dca:3303:1286:257d 50010
permit in 17 from fd18::1:2dca:3303:1286:257d 50010 to 192.168.1.1 34998

But this is not acceptable for the PGW (different ip versions).
The SDP between UE and PCSCF is rewritten by rtpengine/sipwise. Looking at the ims_qos module I found that the address of the proxy is taken from the session original request SDP media ip/port. Having in mind that rtpengine/sipwise proxy is rewritting it is there any way I can set the correct ipv6 address and port of the proxy?

I've tried to get the rewritten media address from SDP (in logs) but without success:
if(sdp_get_line_startswith("$avp(cline)", "c=")) {
xlog("L_INFO", "SDP media ip: $(avp(cline){s.select,2, })\n");
}
if(sdp_get_line_startswith("$avp(mline)", "m=")) {                                                                                                                  
xlog("L_INFO", "SDP media port: $(avp(mline){s.select,1, })\n");
}
I am always getting the ipv4 media address and port of the proxy.

Any idea how I can set and use the rewritten by the rtpengine/sipwise media ip and proxy for the RX AAR?

Thanks in advance,
Pavel Siderov