29 Aug
2008
29 Aug
'08
2:27 p.m.
Dear All
Please find below the call setup from my softphone to my cell phone, The
setup is as follows:
LAN -> Office Gateway <--TLS--->Openser<--UDP-->PSTN GW
I got the trace below by applying
ngrep -W byline -T username -q -d eth0
http://pastebin.com/m2a78a27f
I did the same trace for a udp call and it seemed identical to me, as
you can see in the lower part of the trace that a BYE packet is being
sent to the softphone however the transport is being indicated as UDP
not TLS..is this normal ?
Any clues apart from that ?
Thanks
-----Original Message-----
From: Klaus Darilion [mailto:klaus.mailinglists@pernau.at]
Sent: 2008-08-28 18:13
To: Ali Jawad
Cc: users(a)lists.kamailio.org
Subject: Re: [Kamailio-Users] FW: Call Hangup from Caller-End not
working with TLS
Hi!
Send us an ngrep dump: ngrep -P "" -W byline port 5060
Although this will show us only the UDP part (as TLS is encrypted) but
may still show as the problem.
Which SIP client do you use?
regards
klaus
Ali Jawad schrieb:
Hi All
I am using using openser 1.3..if I make a call between two softphones
on
the same lan or a a pstn call to my mobile phone..and
the
called/receiver party does hang-up the call. It works fine in UDP mode
and the call get's hang-up. However in TLS mode
this does not work.
Anything I might have missed here? Since both udp and tls use the same
routes, and voice is fine and no one way audio ..etc.
I notice this http://pastebin.com/m38c979f6 on rtp proxy. However in
the
logs of openser I can't see any errors.
However on the wire shark I can see icmp destination
unreachable...port
unreachable.
I would have said it is a NAT issue. However it works for simple UDP.
However I did notice the following in the logs
Aug 28 13:41:01 [8565] DBG:tm:set_timer: relative timeout is 4000000
Aug 28 13:41:01 [8565] DBG:tm:insert_timer_unsafe: [7]: 0xb6137794
(45900000)
Aug 28 13:41:01 [8565] DBG:tm:retransmission_handler:
retransmission_handler : done
Aug 28 13:41:02 [8564] DBG:core:parse_msg: SIP Request:
Aug 28 13:41:02 [8564] DBG:core:parse_msg: method: <BYE>
Aug 28 13:41:02 [8564] DBG:core:parse_msg: uri:
<sip:michofr@193.227.186.146:3218;transport=UDP;rinstance=D98C1DD404B200
8F980980E97E42F8EC;nat=yes>
Aug 28 13:41:02 [8564] DBG:core:parse_msg: version: <SIP/2.0>
Aug 28 13:41:02 [8564] DBG:core:parse_headers: flags=2
Aug 28 13:41:02 [8564] DBG:core:parse_via_param: found param type 232,
<branch> =
Shouldn't the transport=TLS ?
Regards
------------------------------------------------------------------------
_______________________________________________
Users mailing list
Users(a)lists.kamailio.org
http://lists.kamailio.org/cgi-bin/mailman/listinfo/users
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.