27 Mar
2006
27 Mar
'06
7:21 p.m.
No, it is not the ports ...
i think then you have a loop in your openser.cfg file ...
The phone can register via any of these ports (whichever you publish
as the registrar ... or if you have DNS and the phone does NPTR,
whatever you set up) ...
You can use any port to route the messages between servers ... just
make up your mind and avoid the loop ...
Actually, you can use all ports to do everything ... it may be
slightly more complex, but it can be worked out :)
So ... i think you have some misconfiguration in the config file ...
Cesc
On 3/27/06, Joao Pereira <joao.pereira(a)fccn.pt> wrote:
No, the phone is in a differente machine.
I believe the problem is in the ports OpenSER is using. That are:
Listening on
udp: XXX.XXX.XXX.XXX [XXX.XXX.XXX.XXX]:5060
tcp: XXX.XXX.XXX.XXX [XXX.XXX.XXX.XXX]:5060
tls: XXX.XXX.XXX.XXX [XXX.XXX.XXX.XXX]:5061
Is this the correct configuration when using TLS?
The SIP clients should use 5060 to register. And the OpenSER should use
5061 to route calls between SIP servers?
Thanks
Joao
Cesc wrote:
One option ...
do you run the phone and server on the same machine? they may be
listening on the same port or something like that ... that is, the
phone sends to the server and the server replies to the contact
address ... which is in fact the server address (the phone didn't tell
you about the port conflict ... too bad :D ). So, you get a loop.
Cesc
On 3/27/06, Joao Pereira <joao.pereira(a)fccn.pt> wrote:
>Hello to all
>Im using openser with TLS (1.0.1-tls) but when I try to register a
>client (X-Lite), the answer is always:
>"Too Many Hops"
>because of this:
>
> if (!mf_process_maxfwd_header("10")) {
> sl_send_reply("483","Too Many Hops");
> exit;
> };
>
>
>
>Whats the problem?
>Without TLS, this error doesnt happen.
>Thanks
>Joao Pereira
>
>_______________________________________________
>Users mailing list
>Users(a)openser.org
>http://openser.org/cgi-bin/mailman/listinfo/users
>
>
>