6 Dec
2006
6 Dec
'06
2:43 p.m.
You need to relay REFER to the other UA, SER should not be involved.
The NOTIFY should not be stopped either, but relayed.
Normally, REFER should be t_relay'ed directly to the UA, but you may
have some NAT issues as the UA never answers. Look at the REFER and see
where it goes.
g-)
jorain wrote:
Hi all,
Is it deal with the ctd.sh script? Configure inside loose_route()?
I can get the REFER message but no responses (202 Accepted and NOTIFY)
to it.
So I send reply 202 inside loose_route if method=REFER.
After that, inside ethereal, I can see the code 202 response to REFER.
However, It send REFER again and after a while 408 TIMEOUT.
This is what i configured:
if(loose_route()){
if(method=="BYE"){
setflag(1);
setflag(2);
};
if(method=="REFER"){
sl_send_reply("202","Accepted");
};
t_relay();
break;
};
Please help.
Thanks in advance
Regards,
jorain
----- Original Message -----
*From:* Greger V. Teigre <mailto:greger@teigre.com>
*To:* jorain <mailto:jorain@caliber.com.sg>
*Sent:* Tuesday, December 05, 2006 9:30 PM
*Subject:* Re: [Serusers] Call transfer
cc serusers
jorain wrote:
Thanks Greger,
Could you give me some clues how to do that or some
references about it? I really have no idea.
Thanks again.
Regards,
jorain
----- Original Message -----
*From:* Greger V. Teigre <mailto:greger@teigre.com>
*To:* jorain <mailto:jorain@caliber.com.sg>
*Cc:* SER+RTPproxy <mailto:serusers@lists.iptel.org>
*Sent:* Monday, December 04, 2006 7:48 PM
*Subject:* Re: [Serusers] Call transfer
Well, yes, you have to route REFER, and you should allow NOTIFYs.
g-)
jorain wrote:
------------------------------------------------------------------------
_______________________________________________
Serusers mailing list
Serusers(a)lists.iptel.org
http://lists.iptel.org/mailman/listinfo/serusers
Hi all,
I have some question about call transfer.
When I press transfer key follow by the new destination and
"send", I can see the REFER message inside ethereal but
after that request timeout error(408).
Inside REFER message, i can see the refer-to and referred-by
values are correct.
Do I need to add something inside ser.cfg to enable call
transfering? Because I cannot find any sample codings
regarding ser call transfer.
Thanks for any help.
Regards,
jorain
------------------------------------------------------------------------
_______________________________________________
Serusers mailing list
Serusers(a)lists.iptel.org
http://lists.iptel.org/mailman/listinfo/serusers