7 Jan
2013
7 Jan
'13
9:46 p.m.
On Fri, Jan 4, 2013 at 4:18 PM, Henning Westerholt <hw(a)kamailio.org> wrote:
Am Donnerstag, 3. Januar 2013, 16:14:59 schrieb Glenn
O Larsen:
>
> Is there a way to read modparam config from a database?
probably the configuration database module - cfg_db is
implementing what you're
searching for. But I personally did not used it so far, so I can't share any
more details.
Thanks for the tip. Unfortunately it seems that this is only used to
replace the core parameters, not module parameters. At least that's
what my testing, and source code browsing has proven/showed me. If I'm
wrong, please tell.
Based on what I have seen (and tried), it seems that its not possible
to extend this module to set the module parameters, since I can't be
sure that module I'm trying to configure, hasn't been loaded yet. Can
someone with deeper module load knowledge confirm this?
--
Best regards,
Glenn Larsen