[Serusers] RE: Configuring SER FOR MULTICAST ADDRESS

Hi all, working by just adding the address in the config file as if it was another address listen = 224.0.1.75 There are a couple of parameters to configure muilticast (see NEWS file): <- new config variables: < mcast_loopback = <yes/no> - loopback sent multicast datagram, default no. < mcast_ttl = number - set multicast ttl, default OS specific (usually 1). So, if you just want to work in your LAN without loopback, just add the multicast address in the config file and SER is going ot listen to it. Remember to have fork=yes in order to enable SER listening to more than one address, just in case you want SER to listen to the multicast and to the "public IP". Sending to multicast should be as sending to a "normal" UDP address, so from SER's config file I guess you can try to send to a multicast address. Cheers, Sam. Unclassified. Dear all, Any suggestions on configuring SER for multicast addressing. Thanks karthikeyan.k ________________________________ From: Innovation Interops Sent: Thu 1/6/2005 5:14 PM To: serusers(a)lists.iptel.org Subject: Configuring SER FOR MULTICAST ADDRESS Dear all, How to configure SER to listen on Multicast address? Regds karthikeyan.k Confidentiality Notice The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain confidential or privileged information. If you are not the intended recipient, please notify the sender at Wipro or Mailadmin(a)wipro.com immediately and destroy all copies of this message and any attachments.