18 Feb
2004
18 Feb
'04
2:16 a.m.
And of course put:
log(1, "blablabla"); and all if, else, etc in config....
On Tue, 2004-02-17 at 12:09, Darren Nay wrote:
I removed it and I still have the same problem. My
onreply_route looks like
this now.
onreply_route[1] {
if (status =~ "(183)|2[0-9][0-9]") {
fix_nated_contact();
force_rtp_proxy();
} else if (nat_uac_test("1")) {
fix_nated_contact();
};
}
I also tried this..
onreply_route[1] {
fix_nated_contact();
force_rtp_proxy();
}
I must admit that I'm new to all this SIP routing. :(
One more thing of note is that we are getting the following errors in the
syslog.
Feb 17 12:53:15 lvl3 /usr/local/sbin/ser[19711]: ERROR: send_rtpp_command:
can't read reply from a RTP proxy
Feb 17 12:53:29 lvl3 /usr/local/sbin/ser[19716]: ERROR: extract_body:
message body has lenght zero
Feb 17 12:53:29 lvl3 /usr/local/sbin/ser[19716]: ERROR: force_rtp_proxy:
can't extract body from the message
Feb 17 12:53:29 lvl3 /usr/local/sbin/ser[19716]: ERROR: on_reply processing
failed
I just noticed this on my last call attempt.
Any more suggestions. I've tried all kinds of combinations .. I'm stumped..
Thanks!
Darren
----- Original Message -----
From: "Maxim Sobolev" <sobomax(a)portaone.com>
To: "Darren Nay" <dnay(a)libertyisp.com>
Cc: <serusers(a)lists.iptel.org>
Sent: Tuesday, February 17, 2004 2:41 PM
Subject: Re: [Serusers] RTP Proxy Help - One way Audio
_______________________________________________
Serusers mailing list
serusers(a)lists.iptel.org
http://lists.iptel.org/mailman/listinfo/serusers
As I said in my previoud message, most likely
that isflagset(6) test in
onreply_route is causing problems. Remove it completely and try again.
-Maxim
Darren Nay wrote:
> Hey Guys,
>
> I am having issues with One way Audio for outgoing phone calls from my
> SIP phones. It works fine for Incoming, but outgoing audio is not
> working. Also, Outgoing works fine if I put my SIP phone on an Internet
> IP address, but if it's NAT'd then I get the 1 way audio on outgoing
calls.
I am using the default nathelper module config, but I have hacked it a
bit and maybe my changes are causing the problem? I had to use
t_relay_to_tcp for our PSTN gateway and so I had to change the routing
around a little.
Prior to today I was using SerMediaProxy (AG Projects), but I switched
to PortaOnes rtpproxy just to make sure that there wasn't a version
incompatibility problem.
I have also attached my current ser.cfg file.
Anyone have any suggestions? Or should I change the routing in my
ser.cfg file? or would that make a difference?
Any help would be greatly appreciated. Thanks!
Darren Nay - dnay(a)libertyisp.com <mailto:dnay@libertyisp.com>
------------------------------------------------------------------------
_______________________________________________
Serusers mailing list
serusers(a)lists.iptel.org
http://lists.iptel.org/mailman/listinfo/serusers