12 Jul
2006
12 Jul
'06
9:45 a.m.
That's a tricky one :-) A few comments:
- I believe bridge mode is necessary and thus rtpproxy is what you need
(mediaproxy does not have this capability AFAIK)
- rtpproxy just waits for the peers to connect, it does not connect rtp
to anything, so if you see traffic from the wrong pstn interface, I
would look at GW
- Just inspect your INVITE and OK SDP to get the options straight: The
one going to your 10. network should have the 10.address in SDP, the one
to your GW, should have your .246 address
- Please note that 0.9.x has a bug (fixed in cvs head). The problem is
related to signalling on different listen ports/interfaces: If SER is
configured to listen to more than one port, the signalling may not
return with the correct src_ip/port (UDP packet, not SIP message). I'm
not sure if this holds for listening on different interfaces as well,
but I would think so
g-)
Fabio Macchi wrote:
Hi,
I'm using SER with nathelper and rtpproxy as a proxy to guard a PSTN
gateway ( calls can only be generated by SIP client and terminated to
PSTN, no SIP to SIP or PSTN to SIP calls allowed, REGISTER is not
needed ).
PSTN gateway and SER eth0 have pubblic internet IP address ( SER eth0
x.x.x.246, PSTN gateway with two interfaces, x.x.x.243 for SIP and
x.x.x.244 for RTP ), SER is setted to force rtpproxy for every call
and rtpproxy is started in standard mode: this is running fine, every
client from internet ( behind a NAT box or not ) is able to place calls.
Now the problem is that I need to collect SIP traffic from another non
routable network to the PSTN gateway ( es. 10.0.0.0 )
I have connected SER interface eth1 to this network ( ip 10.0.0.1 )
and I am trying to connect to the PSTN from a client in the network
10.0.0.0: SIP signaling seems to be ok, but I'm unable to setup RTP
stream.
With this configuration it appears that RTPproxy try to connect to
PSTN gateway on x.x.x.243 and not x.x.x.244.
I have tryied to set RTP proxy in bridge mode ( rtpproxy -l
x.x.x.246/10.0.0.1 ) without succes, but documentation is not very
clear about this case (I think it has been designed for client to
client, not client to PSTNgateway ).
.....
if (dst_ip == x.x.x.246) { #!! Internet IP address
force_rtp_proxy("FI");
t_on_reply("1");
} else if (dst_ip == 10.0.0.1) { #!! Private IP address
force_rtp_proxy("FE");
t_on_reply("1");
};
.....
Now the question is: what is the correct design to implement this ?
RTPproxy in standard mode ?
RTPproxy in bridge mode ? ( how ??? )
Mediaproxy ?
Any help would be appreciated, many thanks in advance.
Fabio
------------------------------------------------------------------------
_______________________________________________
Serusers mailing list
Serusers(a)lists.iptel.org
http://lists.iptel.org/mailman/listinfo/serusers