Hi!
Thank you for the mail.
I have already followed all the steps mentioned in the links .
http://openser.org/dokuwiki/doku.php?id=install_and_maintain_openser_from_c…
http://openser.org/dokuwiki/doku.php?id=make_openser.init_script_work
... pls see my previous mail below.... after all these steps when i actually
want to run openser from /etc/init.d/openser start command, it starts monit
daemon and then the command prompt appears back..... when i go to the
directory /var/run/ i cant see the openser.pid file and also the monit
daemon after a while responds that it could nt start openser. this i can see
at
http://localhost:2812 where the web interface for the monit is
running...........
Please let me know the problem free and preferred source of running
openser.... which is the best way to run openser (is it from binary or cvs)?
Thanks and Regards,
Padmaja
----- Original Message -----
From: "Bogdan-Andrei Iancu" <bogdan(a)voice-system.ro>
To: "Padmaja RV" <padmaja.rv(a)vodcalabs.com>
Cc: <users(a)openser.org>
Sent: Tuesday, May 30, 2006 1:20 PM
Subject: Re: [Users] how to run openser through monit daemon?
Hi,
See
http://openser.org/dokuwiki/doku.php?id=make_openser.init_script_work
regards,
bogdan
Padmaja RV wrote:
Hi all!
I have installed openser through CVS from the following link
http://openser.org/dokuwiki/doku.php?id=install_and_maintain_openser_from_c…
till the 8 th step in the link everything went well fine. in the 9 th
step, there is a link to make oepnser.init script work and i did all the
steps as described. I downloaded and installed the monit daemon to start
openser thru it. however, now if i type /etc/init.d/openser start, it
says command monit to start openser and then the command prompt appears
back. i dont see the tcp and udp ports (5060 ) and other information etc
when the openser is started.....and i cant figure out if it is running at
all.....if i issue ps command, i dont see any pid for openser.....if i
open the web interface of the monit daemon, i see that it is trying to
start the openser but after some time it shows failed to start......
please let me know what to do asap.....
Thanks