I changed Samuel but no use.,,

 my module param is like below:

modparam("permissions", "db_mode", 1)
modparam("permissions", "trusted_table", "trusted")

i think SER is not looking in to trusted table :-

Any ideas,


On 9/15/06, samuel <samu60@gmail.com> wrote:
CC'ing to the list...

Change the from pattern and just place .* (without the ^sip: and the
$) if you want to accept ALL from patterns.

Samuel.

2006/9/15, ravi reddy < mravikreddy@gmail.com>:
> Thanks for your reply Samuel,
>
>   I will get income calls from 6 pstn gateways and i had added all the
> ip-adresses in the trusted table as follows
>    src_ip   proto   from_pattern
>    pstngw   any    ^sip:.*$
>
>  but even though my SER is asking the authentication what i have to do :-(
>
> On 9/15/06, samuel <samu60@gmail.com > wrote:
> > Take a look at the getting started doc and you'll find how to use
> > allow_trusted. For instance:
> >
> > #
> -----------------------------------------------------------------
> > 107. # Call Type Processing Section
> > 108. #
> -----------------------------------------------------------------
> > 109. if (!is_uri_host_local()) {
> > 110. if (is_from_local() || allow_trusted()) {
> > 111. route(4);
> > 112. route(1);
> > 113. } else {
> > 114. sl_send_reply("403", "Forbidden");
> > 115. };
> > 116. break;
> > 117. };
> >
> >
> > You would have to populate the trusted table in the SER's DB with the
> > "trusted" IPs.
> >
> > Samuel.
> >
> > 2006/9/14,
> >
> > ravi reddy <mravikreddy@gmail.com>:
> > > Hi samuel,
> > >
> > >     I am using onsip.org ser.cfg and how can we check allow_trusted is
> true
> > > ?
> > >
> > >                    Thank You for reply.
> > >
> > >  Regards,
> > >  Ravi.
> > >
> > >
> > > On 9/14/06, samuel <samu60@gmail.com> wrote:
> > > > you have to check whether allow_trusted returns true or not before any
> > > > auth. action.
> > > >
> > > > Samuel.
> > > >
> > > > 2006/9/14, ravi reddy < mravikreddy@gmail.com>:
> > > > > Hi ,
> > > > >
> > > > >       When i tried to make a incoming call from pstn to SER its
> asking
> > > for
> > > > > proxy authentication required,
> > > > >
> > > > >   I had entered the pstngw ip address in trusted table even then the
> > > same
> > > > > problem , is any thing else i have to do ;-)
> > > > >
> > > > >   how i can cross this problem.
> > > > >
> > > > >
> Thank
> > > You.
> > > > >
> > > > >  Regards,
> > > > >  Ravi.
> > > > >
> > > > > _______________________________________________
> > > > > Serusers mailing list
> > > > > Serusers@lists.iptel.org
> > > > > http://lists.iptel.org/mailman/listinfo/serusers
> > > > >
> > > > >
> > > > >
> > > >
> > >
> > >
> >
>
>