3 Feb
2006
3 Feb
'06
8:36 a.m.
Elias,
It's dependent on what type of fax your IP-equipment supports. For
example, if your fax on the IP-side supports T.38, you could try this
line within your dail-peer for that destination:
"fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco"
Br,
Tobias
Elias Kaaria said the following on 2006-02-03 06:52:
Dear Tobias,
Thanks you for your assistance on As5350 configurations and sip. Now am
about to configure Fax over IP and Real-Time Fax in my ser sip server. I
will appreciate your input on the same,
Thanking you in advance.
Yours sincerely,
Elias Gitonga kaaria
On 1/12/06, *Tobias Lindgren* <tobias.lindgren(a)ip-only.se
<mailto:tobias.lindgren@ip-only.se>> wrote:
Hello,
Just an example.
dial-peer voice 1234567 voip
huntstop
application session
destination-pattern 01234567.
progress_ind setup enable 3
progress_ind progress enable 8
voice-class codec 10
session protocol sipv2
session target sip-server
dtmf-relay rtp-nte
no vad
!
The "session target sip-server" is configured within "sip-ua".
Br,
/T
Elias Kaaria said the following on 2006-01-10 06:54:
Dear all,
Am about to configure cisco AS5350 to forward calls to Ser Sip server,
kindly forward any configurations for the same.
Kind regards,
Elias Gitonga
------------------------------------------------------------------------
_______________________________________________
Serusers mailing list
serusers(a)lists.iptel.org <mailto:serusers@lists.iptel.org>
http://lists.iptel.org/mailman/listinfo/serusers