18 Mar
2005
18 Mar
'05
12:43 p.m.
You could try rewritehostport("a.b.c.d:5000"); this would send it.
Also for the prefix match , use the lcr module, add your prefixes in
there, and it should select the correct gateway based on call prefix for
you
Iqbal
On 3/18/2005, "Steven Xu" <stevenxiu(a)yahoo.com> wrote:
Hi serusers,
Anybody has a sample ser.cfg that forward calls to Cisco AS5300 GW?
I am using the Nathelper templet config file and got NAT +RTP relay works on IP2IP, but
dont know how to work with PSTN through Cisco AS5300 GW.
where to put the forwording code.
I got some sample code here:
# is it a PSTN destination? (is username nummerical and does not begin with 8?)
if (uri=~"^sip:[0-79][0-9]*@") { # ... forward to gateways then;
# check first to which PSTN destination the requests goes;
# if it is US (prefix "1"), use the gateway XXX.XXX.XXX.XXX...
if (uri=~"^sip:1") {
# strip the leading "1"
strip(1);
forward(XXX.XXX.XXX.XXX, 5060);
} else {
# ... use the gateway YYY.YYY.YYY.YYY for all other destinations
forward(YYY.YYY.YYY.YYY , 5060);
}
break;
}
I dont know if it can talk with Cisco 5300 GW though.
Where should I put it in ser.cfg with NAThelper + RTPreply support?
How to debug the ser.cfg, if i hear busy tone when i dial the PSTN number.
Thanks for your time,
Steve
---------------------------------
Do you Yahoo!?
Yahoo! Small Business - Try our new resources site!