18 Oct
2008
18 Oct
'08
4:08 a.m.
Well, I got the 407 solved - I didn't have my loopback or enet address in
the trusted table.
So, I am closer. Next step is to get a B2BUA installed, like rtpproxy to
handle the audio, since I don't proxy any audio. Any examples out there
where I can initiate the audio for this type of call? Again, I don't
currently nor do I want to handle the audio for 'every' call.
Thanks,
-graham
On 10/12/08 12:45 PM, "Graham Wooden" <graham(a)g-rock.net> wrote:
Gotcha. Well, I re-ran the capture on another test
call and ended the
capture a few seconds after I hung up, and still shows the same path.
Ok, here is my proxy_challenge; I put that xlog in it, and sure enough it's
entering. Now, I have my provider's IP in my trusted table, so I am not
sure why it's challenging...
if (!(method=="REGISTER"))
{
if (!allow_trusted())
{
if (!proxy_authorize("", "subscriber")) {
$var(debug) = proxy_authorize("",
"subscriber");
xlog("L_INFO", "Proxy authentication failed -
M=$rm
RURI=$ru F=$fu T=$tu IP=$si ID=$ci\n");
proxy_challenge("", "0");
exit;
}
fix_nated_sdp("11");
consume_credentials();
# at this point caller is authenticated
}
}
On 10/12/08 12:32 PM, "Juha Heinanen" <jh(a)tutpro.com> wrote:
Graham Wooden writes:
_______________________________________________
Users mailing list
Users(a)lists.kamailio.org
http://lists.kamailio.org/cgi-bin/mailman/listinfo/users Yeah, I see that 407 Proxy Auth too, but I am not
sure where to check for
that.
Here is my only challenge statement:
if (is_method("REGISTER"))
{
if (!www_authorize("", "subscriber"))
{
www_challenge("", "0");
exit;
}
407 comes from proxy_challenge. either your config has one or not all
packets were shown in capture.
this starts to consume too many cycles that are away from writing code.
dig into your config file and make sure that wireshark captures all
packets.
-- juha