If you run a SIP client and the SER proxy on the same box (and assuming same IP address since you’ve left Auto-detect-IP = yes), you need to configure the client to listen to a different port than the standard 5060 which SER is already listening on. On XLite, you can change this in System Settings -> Network.

Regards,

-David

---

From: serusers-bounces@lists.iptel.org [mailto:serusers-bounces@lists.iptel.org] On Behalf Of zahra bahar
Sent: 11 January 2007 09:31
To: serusers@lists.iptel.org
Subject: [Serusers] xlite and ser

my configure in xlite:in system setting
    in network I put these:
    Auto detect IP:yes
    Primary stun server:blank
    in sip proxy I selected default and:
    enabled:yes
    display name:user
    username:1234
    Aotorisation user:1234
    password:1234
    Domain/Realm:10.10.10.138
    sip proxy:10.10.10.138:5060
    use outband proxy:default
    send internal ip:Always
    register:default
    Is it any wrong?this xlite  phone is on a pc that ser server
is.another one is on another PC and only in username and   display and
password differs with  this one.
      I am in the back of a NAT but my two clients and server are
there.
      what is so important in setting xlite?
      thanks.

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com

---

Cheap Talk? Check out Yahoo! Messenger's low PC-to-Phone call rates.