Re: [Serusers] Checking URI

Hi Steve, Here is the route[1] configuration. The calls from outside domains are falling to route[3] which make the call to be blocked.

##Default message handler## route[1] {

t_on_reply("1");

if (!t_relay()) {

if (method=="INVITE" || method=="ACK") { end_media_session(); };

sl_reply_error(); }; }

Thanks, Ryan

Steve Blair wrote:

It looks like the type of call you describe should fall through to route[1] is that the behavior you are seeing? Anyway in route[1] (or somewhere ) you need to accept that the from address might not be a local user and allow for the case where the from address is a "trusted alternate domain like iptel.org". I'm guessing, but I cannot confirm from this code, that route[1] is checking the from user credentials and providing you with the authentication required message.

At that point you could elect, and I think a soft phone will, prompt the user for these credentials.

-Steve

Ryan Pagquil wrote:

...

Hi Steve,

  Here is what happens with my current configuration. When I call 

from my iptel.org account going to my local users it prompts me "407, Proxy Authenctication Required". So what I like to do is to allow those calls going to my local users from other domain. BTW, here is my ser.cfg's INVITE message handler.

##INVITE message Handler## route[3] { if (client_nat_test("3")) { setflag(7); force_rport(); fix_nated_contact(); }; # if (!proxy_authorize("", "subscriber")) { # proxy_challenge("", "0"); # break; # } else

    if (!check_from() && method=="INVITE") {                     

sl_send_reply("403", "User From=ID"); break; };

   lookup("aliases");
   if (uri!=myself) {
           route(1);
           break;
   };

   if (!lookup("location")) {                             

sl_send_reply("404", "User not found"); break; };

   if (method=="CANCEL") {                             route(1);
           break;
   };


   consume_credentials();

   if (isflagset(6) || isflagset(7)) {
           use_media_proxy();
   };

   route(1);

}

I misse call with your SIP phone, just testing it. =)

Thanks, Ryan

Steve Blair wrote:

...

Set the alias=<your sip domain> parameter then use if (uri==myself) construct.

-Steve

Ryan Pagquil wrote:

...

Hello, How can I check if the call is for my domain? What specific module should I use?

Thanks,