RE: [Serusers] Fax problem with SER/Asterisk

Hello. I am working with level3 also... They require inbadn DTMF and you are trying to use rfc2833.. U have to change config of the whatever SIP UA you use from your side and configure it to use G711/inband DTMF _____ From: serusers-bounces(a)iptel.org [mailto:serusers-bounces@lists.iptel.org] On Behalf Of scm-j(a)nuntius.com Sent: Thursday, February 17, 2005 12:33 PM To: serusers(a)lists.iptel.org Subject: [Serusers] Fax problem with SER/Asterisk I am facing some problems with sending fax calls. I am using G.711 codec. However, my service provider (Level-3) does not support T.38 fax relay. According to Level-3 they "think" the problem lies in the "Media Description" field of the SDP message I am sending them. The problem is related to the "Media Format" sub-field (value 101) that I am sending, which according to them should be removed. The SDP "Media Description" field I am sending, looks as follows: "m=audio 20744 RTP/AVP 0 101" which is decoded by Ethereal as follows: Media Type: audio Media Port: 20744 Media Proto: RTP/AVP Media Format: ITU-T G.711 PCMU Media Format: 101 My call is initiated by Asterisk which is sent to Level-3 via SER Asterisk ---> SER ---> Level-3 The SIP call flow looks fine for the call. The sending fax sends the page and then gives an error. The receiving side gives me an error and prints a blank page. My questions are as follows: 1) Could the "Media Format" 101 be the problem? If so, how do I remove the 101? This change is probably in Asterisk, as it initiates the call, and not SER, or probably both. 2) If not, should I be looking elsewhere in SER/Asterisk to solve this problem? regards, SCM