Hi Simon,
I cannot fix it.
Do you mean that you could not fix this problem? If you have fixed this, could you teach me how to configure this?
Thomas
On Thu, 2004-12-23 at 18:42, Simon Miles wrote:
Thomas,
Did you get a resolution to this problem. I had the same problem but then just went back to using port 5060 as I could find a fix.
Thanks
Simon
-----Original Message----- From: serusers-bounces@iptel.org [mailto:serusers-bounces@lists.iptel.org]
On
Behalf Of Thomas Sent: 21 December 2004 06:14 To: serusers@lists.iptel.org Subject: [Serusers] change port -> registration fail
[please ignore my previous message]
Hi everyone,
When I try to change the port from 5060 to other value (e.g. 1234), after restarting SER, the gateway (sipura 2000) fails to register even
I
change the "SIP port" to 1234.
I use serctl ps to view the server process, only port 1234 is used for listening. I use ethereal to trace the packets, when the client sends the REQUEST, my SER server did not reply.
Only 5060 works successfully. Do you have any ideas?
Thomas
Hi,
I know what the problem is. In sipura, I need to specify the proxy server to "yourdomain.com:port" instead of "yourdomain.com" only. This port value should be equal to the port used in ser.cfg. If you don't specify it, 5060 will be assumed.
Finally, I solve this "change port" problem. There is no error for ser-0.8.14.
Thomas
On Fri, 2004-12-24 at 09:58, Thomas wrote:
Hi Simon,
I cannot fix it.
Do you mean that you could not fix this problem? If you have fixed this, could you teach me how to configure this?
Thomas
On Thu, 2004-12-23 at 18:42, Simon Miles wrote:
Thomas,
Did you get a resolution to this problem. I had the same problem but then just went back to using port 5060 as I could find a fix.
Thanks
Simon
-----Original Message----- From: serusers-bounces@iptel.org [mailto:serusers-bounces@lists.iptel.org]
On
Behalf Of Thomas Sent: 21 December 2004 06:14 To: serusers@lists.iptel.org Subject: [Serusers] change port -> registration fail
[please ignore my previous message]
Hi everyone,
When I try to change the port from 5060 to other value (e.g. 1234), after restarting SER, the gateway (sipura 2000) fails to register even
I
change the "SIP port" to 1234.
I use serctl ps to view the server process, only port 1234 is used for listening. I use ethereal to trace the packets, when the client sends the REQUEST, my SER server did not reply.
Only 5060 works successfully. Do you have any ideas?
Thomas
Serusers mailing list serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers
-
Thomas