9 Jun
2006
9 Jun
'06
3:55 a.m.
Hi
How can I do it in such a way maultiple phones behind a single NAT gateway
can call each other using rtpproxy and if these phone calls the PSTN it will
not use rtpproxy, i tried removing the if (isflagset(6)) route(1); on the
these part
if ((uri=~"^(sip:)?00[0-9]*@([a-z]+.)?mydomain.com") ||
(uri=~"^(sip:)?00[0-9]*@1.2.3.4")) {
but can't hear anything on the phones, but if i put if (isflagset(6))
route(1) back it will work. How can I do this? Thank You
Regards,
Nhadie
________________________________________________
Message sent using UebiMiau 2.7
9 Jun
9 Jun
9:42 a.m.
Hi Nhadie,
You want to proxy calls to a PSTN GW if you are calling from behind a
symmetric NAT unless the GW supports active media. Using active media,
it will wait until contacted from the UA and then use the same RTP port
for return RTP. Use fix_nated_sdp("3"). It will change SDP IP address
(but not port) and add direction=active to SDP.
If not using active media, there is no way to get the RTP across the
symmetric NAT.
If you are behind other types of NAT, you can use STUN, but active media
is also fine.
g-)
Nhadie wrote:
Hi
How can I do it in such a way maultiple phones behind a single NAT gateway
can call each other using rtpproxy and if these phone calls the PSTN it will
not use rtpproxy, i tried removing the if (isflagset(6)) route(1); on the
these part
if ((uri=~"^(sip:)?00[0-9]*@([a-z]+.)?mydomain.com") ||
(uri=~"^(sip:)?00[0-9]*@1.2.3.4")) {
but can't hear anything on the phones, but if i put if (isflagset(6))
route(1) back it will work. How can I do this? Thank You
Regards,
Nhadie
________________________________________________
Message sent using UebiMiau 2.7
_______________________________________________
Serusers mailing list
Serusers(a)lists.iptel.org
http://lists.iptel.org/mailman/listinfo/serusers
6728
days inactive
6729
days old
1 comments
2 participants
participants (2)
-
Greger V. Teigre -
Nhadie