Hi,
I know this kind of function exists in Asterisk, but I want to know if Openser can do it as well. Let's say there are two fail-over numbers(DID-b,DID-c) that associates with a DID(DID-a), if the original number(DID-a) that get dailed can't rearch the destination due to BUSY, NO RESPONSE, etc, is there anyway of having Openser to auto-retry with the next DID(DID-b)? If the next one fails, try the next next one(DID-c).
One way I can think of is to do a lookup from DB for the alias in the fail_on_route section, but if I have multiple aliases, then I will have no way of *remembering* which alias has been tried unless I store it in the DB which is not a good solution.
I am wondering if there any other way of doing it?
Thanks in advance for all your kind suggestion.
Regards, Pete
El Monday 26 May 2008 18:52:38 Pete Kay escribió:
You can insert manually some "contacts" into "location" table with "q" value smaller than others (set default value to 1 and manually set 0.1 to manual entries). Later use LRC module or CPL (in this last case look for the option "location sequential" (or something similar). It works.
Hi Bogdan, If I load the avp before I call do the first call. How do I store that AVP so that during failure_route, openser can still find it even it is stateless?
Thanks, Pete
On Tue, May 27, 2008 at 5:38 PM, Bogdan-Andrei Iancu bogdan@voice-system.ro wrote:
And of course, the onreply_avp_mode must be properly set: http://www.openser.org/docs/modules/1.3.x/tm#AEN304
Regards, Ovidiu Sas
On Thu, May 29, 2008 at 11:30 AM, Bogdan-Andrei Iancu bogdan@voice-system.ro wrote:
-
Bogdan-Andrei Iancu -
Iñaki Baz Castillo -
Ovidiu Sas -
Pete Kay