In my humble opinion this was a pretty useful relic from the past and it
pretty much means I cannot upgrade to 1.2 :-(
Are you suggesting that ip should be a primary key in the gw table? It
doesn't make sense to me.
Do you have any other suggestions to achieve what I am trying to do?
thank you
George
-----Original Message-----
From: Juha Heinanen [mailto:jh@tutpro.com]
Sent: Wednesday, April 25, 2007 12:54 PM
To: Papadopoulos Georgios
Cc: users(a)openser.org
Subject: RE: [Users] LCR in cache mode
Papadopoulos Georgios writes:
Well, in my case the IP belongs to an asterisk
server
which then sends > the call to 5 PSTN gateways. I use this
trick with the 5 different > prefixes to make asterisk
choose between the 5 PSTN gateways. It works > fine in db
mode but not in cache mode. Shouldn't lcr behave the same in
both modes?
db_mode does not exist anymore in 1.2. it was relic from the past.
I tried working around this by puting the 5
entries into 5
different gw > groups (this sounds like a bigger hack to me
than what I am currently > doing). Still, in cache mode the
same entry is always picked.
that is because according to the current design of lcr module
a gateway prefix is gateway specific gateways being
identified by their ip addresses. if request matches more
than one gateway, only one of them is left on the list and
the rest are pruned.
-- juha
Disclaimer
The information in this e-mail and any attachments is confidential. It is intended solely
for the attention and use of the named addressee(s). If you are not the intended
recipient, or person responsible for delivering this information to the intended
recipient, please notify the sender immediately. Unless you are the intended recipient or
his/her representative you are not authorized to, and must not, read, copy, distribute,
use or retain this message or any part of it. E-mail transmission cannot be guaranteed to
be secure or error-free as information could be intercepted, corrupted, lost, destroyed,
arrive late or incomplete, or contain viruses.