Quek Eric <inputdev(a)yahoo.com> wrote: thx Steve, actually i dont quite understand e ser.cfg my previous project mate created. here i added tis portion into my ser.cfg...can u teach me where do i call t_on_failure? if(method=="ACK" || method=="INVITE" || method=="BYE"|| method=="REFER") { if(t_newtran()) { t_reply("100","Trying -- just wait a minute!"); if(method=="INVITE" || method=="REFER") { log("**************** vm start -begin ******************\n"); if( uri =~ "conference" ) { if(!vm("/tmp/am_fifo","conference")) { log("could not contact conference server\n"); t_reply("500","could not contact conference server"); }; } else if( uri =~ "echo" ) { if(!vm("/tmp/am_fifo","echo")) { log("could not contact echo\n"); t_reply("500","could not contact echo"); }; } else { if(!vm("/tmp/am_fifo","voicemail")) { log("could not contact voicemail\n"); t_reply("500","could not contact voicemail"); }; }; log("**************** vm start - end ******************\n"); break; }; if(method=="BYE") { log("**************** vm end/refer - begin ******************\n"); if(!vm("/tmp/am_fifo","bye")) { log("could not contact the media server\n"); t_reply("500","could not contact the media server"); }; log("**************** vm end/refer - end ********************\n"); break; }; } else { log("could not create new transaction\n"); sl_send_reply("500","could not create new transaction"); }; }; # Voicemail specific configuration - end Pls do help me... rgds, Eric Sure. Call t_on_failure("7") in route block 0, the main route block in SER. This will define an internal "flag" labeled 7. When the current call "fails" that is does not get a 200 OK message SER will look for a failure block with the label 7 and execute the code therein. Note that 7 is an arbitrary integer. You can pick whatever integer makes you happy and doesn't conflict with existing flags. In the failure_route most people simply re-write the destination hostname and then t_relay the call to that new host. You may need to re-write the port number too. In either case this host and/or port is where your voicemail application is listening. A failure_route is used instead of the regular route statement because you want this section of code to be reached when a status code other than a 200 OK is received for a call. An unanswered call gets something like a 487 (you should check this for the actual number). If you use SEMS you have yet another challenge. When SEMS was first deployed it communicated with SER used a fifo. Since the fifo is not a SIP addressable entity you needed a way for the failure_route to send SIP messages to SEMS. Most people used a second instance of SER on the same box but with a stripped down config file. This second instance could communicate with SEMS using a different named pipe. Newer versions of SEMS do not have this limitation but you need to configure the type of interface SEMS will use. fifo or socket. I did one installation this way but then moved onto using Asterisk for voicemail. Hope this helps. _Steve __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com