Hi guys,
I have tried to Google this for some time now, but can't seem to find an answer.
Is there a way to read modparam config from a database?
Am Donnerstag, 3. Januar 2013, 16:14:59 schrieb Glenn O Larsen:
Hi guys,
I have tried to Google this for some time now, but can't seem to find an answer.
Is there a way to read modparam config from a database?
Hello,
probably the configuration database module - cfg_db is implementing what you're searching for. But I personally did not used it so far, so I can't share any more details.
Best regards,
Henning Westerholt
On Fri, Jan 4, 2013 at 4:18 PM, Henning Westerholt hw@kamailio.org wrote:
Am Donnerstag, 3. Januar 2013, 16:14:59 schrieb Glenn O Larsen:
Is there a way to read modparam config from a database?
probably the configuration database module - cfg_db is implementing what you're searching for. But I personally did not used it so far, so I can't share any more details.
Thanks for the tip. Unfortunately it seems that this is only used to replace the core parameters, not module parameters. At least that's what my testing, and source code browsing has proven/showed me. If I'm wrong, please tell.
Based on what I have seen (and tried), it seems that its not possible to extend this module to set the module parameters, since I can't be sure that module I'm trying to configure, hasn't been loaded yet. Can someone with deeper module load knowledge confirm this?
-- Best regards, Glenn Larsen
7 jan 2013 kl. 20:46 skrev Glenn O Larsen glenn@europlan.no:
On Fri, Jan 4, 2013 at 4:18 PM, Henning Westerholt hw@kamailio.org wrote:
Am Donnerstag, 3. Januar 2013, 16:14:59 schrieb Glenn O Larsen:
Is there a way to read modparam config from a database?
probably the configuration database module - cfg_db is implementing what you're searching for. But I personally did not used it so far, so I can't share any more details.
Thanks for the tip. Unfortunately it seems that this is only used to replace the core parameters, not module parameters. At least that's what my testing, and source code browsing has proven/showed me. If I'm wrong, please tell.
Based on what I have seen (and tried), it seems that its not possible to extend this module to set the module parameters, since I can't be sure that module I'm trying to configure, hasn't been loaded yet. Can someone with deeper module load knowledge confirm this?
In most cases, there should be no need to change modparams at runtime.
Can you tell us more about which parameter you want to change during runtime that doesn't have a mI/rpc reload command?
/O
-
Glenn O Larsen -
Henning Westerholt -
Olle E. Johansson