Hi Marian!

I didn't know such an parameter for usrloc even existed, it wasn't mentioned in the (rather old) documentation. I'm currently using 0.8.99-dev10 and found a "use_domain" parameter for module "usrloc" in the sources. There was a parameter "use_domain" for module "registrar" mentioned in the manuals too, but ser complains that "registrar" doesn't have such a parameter.

But "modparam("usrloc", "use_domain", 1)" didn't do the desired effect. Calls still not work from SIP-phone to SIP-phone. "serctl ul show" shows only those "aor"s:

aor : '31@100.100.100.100' aor : '32@100.100.100.100' aor : '30@mydomain.org'

(IPs and names changed accordingly to the example below)

The X-Lite UA also has problems reaching one of the hard-phones by dialing the two-digit number (e.g. "31", generating an INVITE to "sip:31@mydomain.org"). Only when the IP of the ser is added, the call comes through (e.g. dialling "31@100.100.100.100", giving an INVITE: "sip:31@100.100.100.100")

Best regards, Alex Mack

Marian Dumitru wrote:

Hi Alex,

Have you enabled "use_domain" parameter for usrloc module? If you set it to 0 (as default) usrloc will not use the domain part to perform usrloc lookup.

Best regards, Marian Dumitru

Alex Mack wrote:

...

Hi!

I'm using ser with X-Ten Lite Soft-UA and Siemens optiPoint 400 IP phones. Problem is: the Siemens phones don't register themselves correctly.

For example: (e.g., ser has IP 100.100.100.100)

Soft-UA is "sip:30@mydomain.org" Phone 1 is "sip:31@mydomain.org" Phone 2 is "sip:32@mydomain.org"

Soft-UA registers itself as "sip:30@mydomain.org" Phone 1 registers itself as "sip:31@100.100.100.100" (seems to be odd behaviour) Phone 2 registers itself as "sip:32@100.100.100.100"

But now the lookup fails if you start dialing from the phones. If you dial "32" (e.g. from Phone 1), the phone generates an INVITE to "sip:32@mydomain.org" which can't be found in usrloc (DEBUG tells that) and the call fails. If you dial "30" from the same phone, the call comes through, because "sip:30@mydomain.org" was found in usrloc. I tried to mangle the uri in the REGISTER message before "save("location");", without effect. I've used "replace(re, str)", but it didn't seem to work.

Any ideas to overcome that bug of the phones?

Thanks! Alex.

---

Serusers mailing list serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers