5 Jul
2013
5 Jul
'13
11:10 a.m.
I am still a little baffled by the new LCR table structures and i am having
a hard time figuring out how to use them. I want to different LCR gateways
for two different prefixes. When I load up this configuration,
lcr.dump_gws is only returning the Gateway with Lcr ID: 1. What am I doing
wrong here?
Here is my current table structure:
----------------------------------------
LCR Gateway List
----------------------------------------
Id 1
Lcr Id 1
Gw Name: Host 1
Ip Addr: X.X.X.X
Uri: 1
Transport 1
Id 2
Lcr ID 2
Gw Name: Host 2
Ip Addr: Y.Y.Y.Y
Uri: 1
Transport 1
----------------------------------------
LCR Rule List:
----------------------------------------
Id: 1
Lcr Id: 1
Prefix: 1555
Stopper 0
Enabled 1
Id: 2
Lcr Id: 2
Prefix: 1444
Stopper: 0
Enabled: 1
----------------------------------------
LCR Target List:
----------------------------------------
Id: 1
Lcr Id: 1
Rule Id: 1
Gw Id: 1
Id: 2
Lcr Id: 2
Rule Id: 2
Gw Id: 2
5 Jul
5 Jul
12:17 p.m.
Geoffrey Mina writes:
I am still a little baffled by the new LCR table
structures and i am having
a hard time figuring out how to use them. I want to different LCR gateways
for two different prefixes. When I load up this configuration,
lcr.dump_gws is only returning the Gateway with Lcr ID: 1. What am I doing
wrong here?
perhaps you have not set lcr_count module param. it defaults to 1.
-- juha
2:58 p.m.
OK. I updated that to 10 and now it loads both. Is there any harm in
making it 100 even though I will never use that many? Just so I don't need
to restart Kamailio to add new routes?
On Fri, Jul 5, 2013 at 10:17 AM, Juha Heinanen <jh(a)tutpro.com> wrote:
Geoffrey Mina writes:
I am still a little baffled by the new LCR table
structures and i am
having
a hard time figuring out how to use them. I want
to different LCR
gateways
for two different prefixes. When I load up this
configuration,
lcr.dump_gws is only returning the Gateway with Lcr ID: 1. What am I
doing
wrong here?
perhaps you have not set lcr_count module param. it defaults to 1.
-- juha
_______________________________________________
SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list
sr-users(a)lists.sip-router.org
http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users
3:06 p.m.
Geoffrey Mina writes:
OK. I updated that to 10 and now it loads both. Is
there any harm in
making it 100 even though I will never use that many? Just so I don't need
to restart Kamailio to add new routes?
the param is there in order to save shared memory and speed up those
functions that operate on lcr instances. if you don't run out of shm
memory, you can set lcr_count to whatever value you wish.
-- juha
4244
days inactive
4244
days old
4 comments
2 participants
participants (2)
-
Geoffrey Mina -
Juha Heinanen