6 Mar
2008
6 Mar
'08
6:23 p.m.
2008/3/6, Ross Beer <ross_beer(a)hotmail.com>om>:
Just general sip message problems, i.e. if a user is
behind a firewall.
Take a look at the following commands:
force_rport
fix_nated_contact
fix_nated_sdp
force_rtp_proxy
Don't forget also to mark (with setflag()) registered users behind NAT
and fix replies in onreply_route.
I think I need to use the NAT Helper module, however I
can not seam to
pass registrations on to Asterisk.
BTW don't forget to CC to users(a)openser.org (this maillist badly configured)
--
With best regards!
6 Mar
6 Mar
6:33 p.m.
New subject: [OpenSER-Users] OpenSER & NAT Help
On Thursday 06 March 2008, Peter Lemenkov wrote:
[..]
BTW don't forget to CC to users(a)openser.org (this maillist badly
configured)
Hi Peter,
the correct address of this list is 'users(a)lists.openser.org'org', but
'users(a)openser.org' works too. If just reply to a email, then the reply goes
to the list, and a CC to the OP. So its not necessary to add another CC to
the address you've given above.
Cheers,
Henning
6:38 p.m.
New subject: [OpenSER-Users] OpenSER & NAT Help
On Thursday 06 March 2008, Henning Westerholt wrote:
If just reply to a email, then the reply
goes to the list, and a CC to the OP. So its not necessary to add another
CC to the address you've given above.
To be a little bit more precice:
If you choose 'reply' in your mail client, then the mail only goes to the
list. If you choose 'reply all', then the mail goes to the list and to the
OP. This is just the way the openser.org lists are configured. Sure, there
are different ways, but both have their pros and cons so i don't see much
value in arguing about this.
Cheers,
Henning
6108
days inactive
6108
days old
2 comments
2 participants
participants (2)
-
Henning Westerholt -
Peter Lemenkov