Hi
I have added rpid for each username in my DB and they are being picked up fine
save_rpid(): rpid value is '123456789' 4(2890) authorize(): set string AVP 'rpid = 123456789'
but when a call is made this is not being sent as the CLI, in fact I dont get a callerid.
I added append_hf to my routing block, after authorising, and after the correct gateway had been looked up, but alas no luck, anyone have a sample CLI route.
Iqbal
Can you see the Remote-Party-ID header field in the outgoing message ? If so then most likely the user agent does not support it.
Jan.
On 25-04 21:28, Iqbal wrote:
Hi
I have added rpid for each username in my DB and they are being picked up fine
save_rpid(): rpid value is '123456789' 4(2890) authorize(): set string AVP 'rpid = 123456789'
but when a call is made this is not being sent as the CLI, in fact I dont get a callerid.
I added append_hf to my routing block, after authorising, and after the correct gateway had been looked up, but alas no luck, anyone have a sample CLI route.
Iqbal
Serusers mailing list serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers
-
Iqbal -
Jan Janak