Hi, Before launching ser, check your config file with ser -c. If there are any errors the line and the column ,where is the error, are shown.

Debug messages you can find in your kernel messages (e.g /var/log/messages) when you have enabled log_stderror=no in your config file.

When you enable fork=yes, ser is listening on all interfaces.

Regards, G�rard

--- Simith Nambiar simith@indtelesoft.com wrote:

Hi All, I'am new to Ser , and hope this is the right list to ask. I get the following error on running Ser, what could be the problem ? and some hint on where to look for to fix my config file ? or something else would be very much helpful !

============================================================================

==== WARNING: no fork mode and more than one listen address found(will use only the the first one) stateless - initializing 0(0) Maxfwd module- initializing textops - initializing ERROR: error -478 while trying to fix configuration

============================================================================

====

Thank you.

Cheers. simith

---

Serusers mailing list serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers

__________________________________ Yahoo! Mail Mobile Take Yahoo! Mail with you! Check email on your mobile phone. http://mobile.yahoo.com/learn/mail