6 Dec
2007
6 Dec
'07
1:03 p.m.
Hi
I'm kind of newbie at all the SER issue so sorry for bothering you with
my questions.
I defined at ser.cfg to listen on port 5066 instead of default 5060
port, saved changes and restarted the SER.
At Wireshark sniffer I see that there is an ICMP--> Destination Port
Unreachable response on all sip REGISTER requests arrived from various
endpoints at my setup.
As far as I understand this means that configured 5066 port is not bound
with SER application.
So my question is: where can I see, how is "myself" built or
concatenation of which parameters creates "myself" value?
Thanks
6 Dec
6 Dec
1:44 p.m.
Hi Evgeny,
I defined at ser.cfg to listen on port 5066 instead of
default 5060
port, saved changes and restarted the SER.
As a consequence you also should
- change the DNS SRV records to point to port 5066,
- or configure all clients to use the SER-IP:port as an outbound proxy.
At Wireshark sniffer I see that there is an ICMP-->
Destination Port
Unreachable response on all sip REGISTER requests arrived from various
endpoints at my setup.
Obviously these are related to REGISTER requests addressed to the default
port, where SER does not listen anymore.
As far as I understand this means that configured 5066
port is not bound
with SER application.
No. 5066 is bound to SER application, but the ICMP messages are produced
by SIP requests targetted to port 5060.
Franz
6206
days inactive
6206
days old
1 comments
2 participants
participants (2)
-
Evgeny Miloslavsky -
franz.edler＠inode.at