Hi All, thought I would give you a small little perl program I quickly hacked up to help with some memory leaks I was getting. Turns out I was forgetting to call release_urecord after a get_urecord on the usrloc module. Because I use Kamailio in DBOnly mode - the memory was never being freed. This little program helped me to find the source in no time at all. I hope it helps you too. A little info: The program works on the log file. NB you have to have memlog debugging enabled for this program to do anything useful. Effectively the program continuously monitors the log file looking for allocs and frees. It tallies all the fragments in use and gives a report of all the fragments and where they weer allocated. It also keeps a running counter of bytes used. Here is an example of the output: ***************************************************************************************************************************************************** DUMPING ALL UNFREED MEMORY FRAGMENTS (25) ***************************************************************************************************************************************************** called from h_table.c: build_cell(251) 6 21312 called from dlg.c: new_dlg_uac(169) 1 128 called from t_msgbuilder.c: build_uac_req(921) 6 1896 called from pv_svar.c: set_var_value(104) 3 132 called from ../../ut.h: shm_str_dup(501) 2 48 called from reply.c: build_contact(127) 1 132 called from t_hooks.c: insert_tmcb(108) 6 144 ************************************************************TOTAL BYTES HELD IN FRAGMENTS: 23792*************************************************************** To use - simply untar into a directory and run ./memalyze.pl Hope it helps Cheers Jason