Ok, I worked out that you need to use append_branch, like this: append_branch (proxy1) append_branch (proxy1) t_replicate (proxy3) That's what the devevelopers say anyway... However, all the t_replicate's are going to exactly the same proxy. Here's a post by two people that have reported _exactly_ the same problem. Is there a solution? http://www.archivum.info/serusers@iptel.org/2004-12/msg00268.html Thanks, Doug. -----Original Message----- From: Douglas Garstang Sent: Wednesday, November 30, 2005 4:11 PM To: users(a)openser.org Subject: [Users] t_replicate after failure In the scenario below, if the first t_replicate fails because 192.168.10.5 returns "Not Found", the second t_replicate command does not execute. Why? How can I make it execute? Call me crazy, but this doesn't seem at all intuitive to me. In a functional programming world, if the first fails, the next should still run. if (method=="REGISTER") { # Uncomment this if you want to use digest authentication if (!www_authorize("voip.com", "subscriber")) { www_challenge("voip.com", "0"); exit; }; save("location"); t_replicate("192.168.10.5","5060"); t_replicate("192.168.10.7","5060"); exit; }; Thanks, Doug. _______________________________________________ Users mailing list Users(a)openser.org http://openser.org/cgi-bin/mailman/listinfo/users _______________________________________________ Users mailing list Users(a)openser.org http://openser.org/cgi-bin/mailman/listinfo/users