Hello Inaki,
I wasn't aware of this parameter and I am using the deault (matching contact only).
However this does not aswer my question.
Sipsak has a default expires of 15 sec for the registration. I run sipsak every 2 minutes.
So every time that sipsak runs, Openser should not find any valid entries in usrloc.
Also note that I am using the default cseq_delay which is 20 sec. Any other ideas?
thank you
George
Date: Wed, 17 Oct 2007 10:09:51 +0200
From: I?aki Baz Castillo <ibc(a)in.ilimit.es>
Subject: Re: [OpenSER-Users] using sipsak to check openser
To: users(a)openser.org
Message-ID: <200710171009.51575.ibc(a)in.ilimit.es>
Content-Type: text/plain; charset="ISO-8859-1"
El Wednesday 17 October 2007 09:51:43 Papadopoulos Georgios escribiσ:
sipsak is running on the same server with
Openser. Since
the CSeq is 2
it means that Openser has received the first
REGISTER, has
asked for
authentication, sipsak replied, but then Openser
says "Invalid CSeq
number". Has anyone seen this happen before and/or has a reasonable
explanation?
Not sure, but maybe this can help you:
http://www.openser.org/docs/modules/1.3.x/usrloc.html#CONTACT-
MATCHING-ALGS
--
Iρaki Baz Castillo
ibc(a)in.ilimit.es
Disclaimer
The information in this e-mail and any attachments is confidential. It is intended solely
for the attention and use of the named addressee(s). If you are not the intended
recipient, or person responsible for delivering this information to the intended
recipient, please notify the sender immediately. Unless you are the intended recipient or
his/her representative you are not authorized to, and must not, read, copy, distribute,
use or retain this message or any part of it. E-mail transmission cannot be guaranteed to
be secure or error-free as information could be intercepted, corrupted, lost, destroyed,
arrive late or incomplete, or contain viruses.