New subject: [Users] acc_radius question

11 Oct 2006

Hi,

i use both setfalg(x), and acc_rad_request
i need accounting for INVITE, ACK (for INVITE), CANCEL, BYE
it was working ubkess error, but now i try failed_transaction flag.
Could you help me in some better solution,
I need acc_rad_request becasue of i need invite accounting immediately - 
for set the call setuptime
ack - for set the call connecttime
bye - for disconnecttime

So i done it this way:
(config in question)

modparam("acc", "radius_flag", 1)
modparam("acc", "radius_missed_flag", 2)
modparam("acc", "failed_transaction_flag", 4)

    if (is_method("ACK") || is_method("BYE")) {
       setflag(1);
       setflag(2);
       setflag(4);
    };

    # accounting requests

    if (is_method("INVITE")) {
                if (!radius_www_authorize("$rd")) {
                    www_challenge("$rd", "0");
                    exit;
                };
                acc_rad_request("200 Invite received...");
                consume_credentials();
    }
    else if (is_method("ACK")) {
       if (t_check_status("[4-6][0-9][0-9]")) {
           acc_rad_request("Failed");
       }
       else {
           acc_rad_request("200 Ack received...");
       };
    }
    else if (is_method("BYE")) {
    }
    else if (is_method("CANCEL")) {
        acc_rad_request("200 CANCEL received...");
    };

Thanks,
Tamas

raviprakash sunkara wrote:

...
  Can U send the Config

 U didn't set the  flags properly in ur Config file
 and
 Don't use  setflag("x");

 Use acc_rad_request("200");

 On 10/11/06, Cseke Tamas &lt;cseke.tamas(a)eworldcom.hu&gt; wrote:

 Hi,

 When sends openser accounting packets for INVITE, and BYE message?
 it seems to be, when received 200 OK.

 1)for INVITE i need radius packet immediately, not just when it was
 answered.
 2)for BYE i need accounting packet, when any error occured too.

 modparam("acc", "radius_flag", 2)

 modparam("acc", "radius_missed_flag", 3)

 this attribute mean that, should sent radius packet, when any error
 occured too, isn't it? However openser don't send accounting packet in
 this case.

 i run into the following error:

 ##########
 T called -> openser
   BYE sip:21.16.8.92:5060
 ##
 T openser->called
   SIP/2.0 477 Unfortunately error on sending to next hop occurred 
 (477/TM)
 ##########
 T caller->openser
   BYE sip:66610038641368254@21.16.8.90:5060;
 #####
 # openser -> caller
   SIP/2.0 481 Call Leg/Transaction Does Not Exist..

 So no 200 OK for BYE received, therefore no accounting packet to radius
 sent.
 How can i solve these problems?

 Btw, what could cause this 477 error?

 Thanks,
 Tamas

 _______________________________________________
 Users mailing list
 Users(a)openser.org
 http://openser.org/cgi-bin/mailman/listinfo/users

Re: [Users] acc_radius question